Quick answer: Specify a rebar arc bending machine using bar diameter and grade, target radius or diameter, arc angle, part length and required dimensional tolerance. Test the actual material because springback and bar condition can affect the finished curve.
Define the finished curve
State whether the drawing gives an inside radius, centerline radius or finished diameter. Mark the arc angle, straight ends, overall length and any connection points. Use one consistent reference when comparing supplier proposals.
Account for material and springback
Bar grade, diameter, rib profile and batch condition can influence the final curve. Ask the supplier to run a sample using the intended material and record the setup and measurement method. Avoid assuming that a result on a different bar grade will transfer directly.
Check the complete machine scope
Confirm the bending range, tooling, control method, standard accessories, electrical supply and installation requirements. Ask how the operator measures the first part and what adjustments are permitted under the operating instructions.
Frequently asked questions
Is a radius the same as a diameter?
No. Make the drawing reference explicit and confirm whether the requested dimension is measured to the inside, centerline or outside of the bar.
What is a useful acceptance sample?
A sample made from the agreed material and drawing, measured at agreed points against the specified tolerance.
Contact Haihui Machinery: Phone / WhatsApp +86 139 3296 0232. Send an arc drawing for a preliminary model review.
