HAIHUI · APPLICATION PLANNING CASE
This is an illustrative equipment application, not a report of a named customer order or verified operating results. The product image shows Haihui equipment, not an installation at the illustrative site.
Application at a glance
A precast reinforcement workshop needs rectangular ties for several beam families. The planning problem is keeping dimensions, hook details and batch identification consistent when drawings share a similar appearance.
| Item | Requirement |
|---|---|
| Finished part | Rectangular beam ties, with all hook details taken from approved drawings |
| Incoming material | Coiled reinforcing steel; diameter and grade subject to configuration review |
| Candidate equipment | Máquina dobradeira de estribo de vergalhão CNC Haihui HH4-14S |
| Acceptance evidence | Measured sample parts, batch counts and material identification |
Translate the beam drawing into a production job
For this application, the workshop would issue one controlled job sheet for each tie drawing. It should identify the dimension reference, grau da barra, diâmetro, hook geometry and required quantity. Similar-looking ties should receive different job identifiers. The machine program should be checked against the current drawing revision before a repeat batch is released.
Review the HH4-14S against the actual tie
The current Haihui product page lists 4–14 mm single-wire and 4–10 mm double-wire ranges. These ranges help shortlist the machine; they do not establish suitability for every small tie, hook or steel grade. Ask Haihui to review the smallest tie and most demanding bend, then demonstrate representative material and tooling.
Use a first-piece approval and a batch record
A practical trial would measure the released tie against agreed dimensions, verify the hook details and record the material and settings. Include a check after a diameter or program change. Separate accepted pieces from samples awaiting approval, and label completed bundles so the assembly team can match them to the correct beam job.
Assess the complete tie-production cycle
Count accepted ties over a representative run that includes setup and finished-part handling. The catalog reference of approximately 2,000 peças por hora para 20 × 20 cm stirrups is not a promised rate for every beam tie. Compare the demonstrated result with the actual part mix before choosing the configuration.
Related equipment and product category
Revise o Máquina dobradeira de estribo de vergalhão CNC HH4-14S for current product information, and browse the Máquina dobradeira de vergalhão CNC category. Model selection should be based on the actual material, drawing and agreed configuration.
Application FAQ
Can double-wire mode be used for every tie?
Não. Material, diâmetro, shape and the confirmed setup must be reviewed together. The published double-wire range is 4–10 mm.
What should I send Haihui for a similar application?
Send dimensioned drawings, material grade and sizes, target batch quantities, available electrical supply and destination country. Include the acceptance requirements and existing upstream or downstream equipment so the proposed scope can be reviewed.
Discuta seu projeto com Haihui
Xingtai Haihui Máquina-ferramenta Co., Ltda. supplies rebar processing machinery from Renze District, Xingtai, Hebei, China. Contact the factory to discuss a configuration for your own application and request a written quotation.
WhatsApp / Telefone: +86 13932960232 · 417786525@qq.com · Send an enquiry