Máy uốn CNC, CNC steel bar straightening and bending machine

Parameter: Processing round steel/threaded steel with a diameter of 4-12mm

The total power of the pneumatic steel bar bending machine is 31.5kw

Straightening servo motor power/bending clamp servo motor power/flying knife cutting motor power/air pump power: 18kw/7.5kw/5.5kw/4.0kw

Production: 1800-2200 units/hour.

Packaging instructions for steel bar bending machine: domestic ordinary packaging, export wooden box packaging.

After sales service: 18 months

Price of CNC steel bar straightening and bending machine Product features:

★ φ 4-12mm coil reinforcement → straightening → bending → shearing for one person operation

★ Actual power consumption: 4-5.5kw/h, integrating straightening, chiều dài, uốn cong, and shearing

★ High production efficiency adopts servo drive, with fast speed, high output, and low failure rate.

Advantages of CNC bending machine products:

1. From wire rod raw materials to stirrup products, it can be processed into cold and hot rolled high-strength wire rod steel bars in one go.

2. High production efficiency, equivalent to 20 to 30 manual labor.

3. The device has strong practicality and can be operated by only one person, saving a lot of labor.

4. Saving raw materials, continuous forming in work with minimal loss of steel bar material.

5. Small footprint, saving straightening and cutting work areas, allowing for operations in narrow areas.

Introduction to the installation instructions for the steel bar straightening and bending machine:

Installed on the foundation. Whether fixed with anchor bolts or not, horizontal adjustment is required. Place several adjustable guide rails for horizontal support between the bed frame and the base. The commonly used adjustment support is the horn. The adjustment of the CNC hoop bending machine on the foundation should be first flattened and then leveled, that is, roughly leveled before injecting the anchor bolt hole, and the horizontal adjustment work should be carried out when tightening the nut of the anchor bolt. Tightening should not be done by tightening the anchor bolts or partial pressure to achieve accuracy requirements.

(1) After completing the assembly, the bending machine needs to be cleaned and cleaned on site.

(2) Check the lubricating oil circuit of the bending machine, and inject lubricating oil and coolant that meet the specifications according to the lubrication diagram requirements to meet the specified requirements.

(3) Check if the fasteners are reliable; Is the contact between the sliding plate and the moving surface of the tailstock good, and is the pressure plate tightened.

(4) Rotating the transmission components by hand requires flexible operation; Each gear shift and shift lever should be reliably and flexibly positioned; The movement of each moving mechanism should be flexible, without obstruction, and the amount of reverse air travel should be very small.