Haihui GWH24 GWH32 steel circle and rebar arc bending machine, WhatsApp +86 13932960232

Машина для дуговой гибки арматуры: Определить радиус, Угол и прием образца

Быстрый ответ: Specify a rebar arc bending machine using bar diameter and grade, target radius or diameter, arc angle, part length and required dimensional tolerance. Test the actual material because springback and bar condition can affect the finished curve.

Define the finished curve

State whether the drawing gives an inside radius, centerline radius or finished diameter. Mark the arc angle, straight ends, overall length and any connection points. Use one consistent reference when comparing supplier proposals.

Account for material and springback

Барный сорт, диаметр, rib profile and batch condition can influence the final curve. Ask the supplier to run a sample using the intended material and record the setup and measurement method. Avoid assuming that a result on a different bar grade will transfer directly.

Check the complete machine scope

Confirm the bending range, оснастка, control method, стандартные аксессуары, electrical supply and installation requirements. Ask how the operator measures the first part and what adjustments are permitted under the operating instructions.

Часто задаваемые вопросы

Is a radius the same as a diameter?

Нет. Make the drawing reference explicit and confirm whether the requested dimension is measured to the inside, centerline or outside of the bar.

What is a useful acceptance sample?

A sample made from the agreed material and drawing, measured at agreed points against the specified tolerance.

Связаться с Haihui Machinery: Телефон / WhatsApp +86 139 3296 0232. Send an arc drawing for a preliminary model review.

Пролистать наверх