Automatic Curved Stirrup Bending: A Practical Production Workflow

إجابة سريعة: A reliable workflow for automatic curved stirrup bending begins with drawing review, material confirmation and a representative trial. Operators should verify the program and tooling, observe the first pieces and measure samples before continuing a production batch.

1. Review drawings and material

Confirm the shape dimensions, curve radius, bar diameter and steel grade before setting up. Resolve unclear drawing details with the project team and machine supplier. Keep the approved drawing and configuration available to the operator.

2. Prepare the machine and tooling

Follow the machine manual and the supplier’s safety and setup instructions. Check that the selected tooling and machine configuration match the approved shape and material. Make sure the work area is clear and that operators understand the emergency stop and guarding requirements.

3. Run and inspect a sample

Produce an initial sample and compare its overall dimensions, curve and legs with the drawing. If the sample is outside the agreed tolerance, stop and investigate the setup before proceeding. Record the approved settings and sample measurements so the production team can follow a consistent reference.

4. Monitor the batch

Inspect pieces at an agreed interval and after any change to material, tooling or program. Track rejected parts and communicate recurring deviations. Production rate depends on the part geometry, مادة, setup and operator practice, so buyers should confirm output expectations through a test rather than rely on a general machine label.

الأسئلة المتداولة

Does automation remove the need for inspection?

لا. First-piece and in-process checks help identify setup or material issues before they affect a larger batch.

What should a factory demonstration show?

Ask to see the agreed material, representative shape, operating sequence and measured finished sample, with the machine configuration identified.

اسأل هايهوي: شركة شينغتاي هايهوي للأدوات الآلية المحدودة, المحدودة. يقع مقرها في شينغتاى, خبي, الصين. Share your rebar diameter, درجة الصلب, target shape, daily output and destination country for a suitable configuration and quotation. واتساب: +86 139 3296 0232.

انتقل إلى أعلى